That is a great idea! The Morgan would need the rails moved appart to each side of the pulleys so you can use the two for both sides. The frame would need to be reworked but it can be done.
I was hoping that 4 could be done at the same time with the elbow joints shared but some mental math shot that idea down. 3 without shared elbows would probably be the coolest machine on earth. I might mock that up for grins.
You can also use standard electronics for this because all the extruders could be slaved together mechanically. Three printers for the price of one.
Keep up the crazy ideas!
I was hoping that 4 could be done at the same time with the elbow joints shared but some mental math shot that idea down. 3 without shared elbows would probably be the coolest machine on earth. I might mock that up for grins.
You can also use standard electronics for this because all the extruders could be slaved together mechanically. Three printers for the price of one.
Keep up the crazy ideas!